uper control arms
3 posters
Page 1 of 1
uper control arms
hi guys i have a bit of a squeaky front end and don't have grease nibbles on the upper arm bushings .dose any one know if you can fit them on the arm while still in the car or do i need to pull the arms out thanks
65birdman- Posts : 75
Join date : 2012-04-24
Re: uper control arms
Hi Birdman
I have a 65 bird and I had the same problem. You can buy right angle grease nipples. I bought mine from Bursons. What you have to do is separate nipple then screw threaded piece into bush then screw nipple in. It's a tedious job but can be done. Good Luck. Kev.
I have a 65 bird and I had the same problem. You can buy right angle grease nipples. I bought mine from Bursons. What you have to do is separate nipple then screw threaded piece into bush then screw nipple in. It's a tedious job but can be done. Good Luck. Kev.
spits 65 bird- Posts : 114
Join date : 2012-03-18
Age : 64
Location : Altona Vic
Re: uper control arms
thanks kev will give it ago . man i love your wheels
65birdman- Posts : 75
Join date : 2012-04-24
Re: uper control arms
managed to get both drivers side done and one on the front side of the passengers side but the back side of the passengers side is a real bugger only about 14 mm of room
65birdman- Posts : 75
Join date : 2012-04-24
Re: uper control arms
I have read that you can use a hole saw to cut a hole opposite the grease point and put the nipple on, a straight one. The hole will be hidden so not a bad idea.
graeme
graeme
rhinosoft- Posts : 124
Join date : 2012-03-19
Location : Ringwood East
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|